Questions & Answers for: injector sleeve

Question about 2001 Silverado 2500HD

1 Answer

...Injector Sleeve) Some owners may comment on engine coolant loss with no visible leaks. Excessive white smoke or a coolant type odor coming from the exhaust pipe, along with low coolant levels, ...

Ad

Question about 2000 F350 Super Duty Super Cab

3 Answers

...much longer thats the only place it could come from,,, I'd have cooling system pressure tested with injectors out, as I suspect cracked injector sleeves, unless head gasket is bad, but I'd check the ...

Ad

aftermarket injector kit is slightly different than stock on my 96 5.7L 350 vortec. is there anything i need to do differently? my stock ones clip in to the lower intake and the new one doesn't have ...

...no need to drain the fuel rail - if the engine coolant is found in the chambers,it may be necessary to install a new injector sleeve. Remove the bolt, fuel injector hold-down clamp and fuel

Question about 1998 Trooper

1 Answer

...injector sleeve O rings have failed this was common. if you put a clear plastic piece of hose on supply line for diesel fuel filter to head fitting at front and fuel is not black but normal diesel ...

Cost of labor to replace injectors sleeve in ford 2004 6.0l f550 Most dealers charge about $100 per hr. That job should not be over 1 hr., 2 hr's if they have to replace all the injectors. Hope this ...

Question about 2004 F550

2 Answers

...sleeve with new seals and copper seat plus injector seal installed to correct tightening sequence is the trick. Make sure the bottom seal on the sleeve is well lubricated with petroleum jelly or ...

Just finished installing rebuilt injectors and new sleeves on my 2001 7.3 in an F350. Won't start. Hand cranked engine with glow plugs out to clear cylinders. Hand cranked after glow plugs installed ...

...injector copper sleeve on fiat 500 tractor cylinderhead. from memory, the sleeve is inserted and then fitted by the use of special expanding tool designed to do the job talk with an engine ...

I'm removing my fuel rails on a V10 6.8 l 99 I unclipped all the fuel injector and coil plug connectors. There's two plastic sleeves on the end of the plastic cover for the electrical rail with all ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...