Questions & Answers for: impala maf sensor

...Impala not starting.. It will Start, shake and sputter, and then cut out. You wait like 30-45 minutes and it will start right up.. Has been happening more and more, I noticed only on Hot days.. Now I ...

...Impala code PO102 is mass air flow sensor circuit low frequency condition.what it is saying.MAF sensor element hot wire contaminated or sensor failed.MAF sensor signal shorted to ground or grounded ...

...maf sensor on 2000 chevy impala 3.8l Series II 3.8 litre. Remove the cover that is on top of the engine by removing the the oil cap and and the neck into the valve cover.The throttle body will be on ...

...impala my check engine light is on & the dtc is po171>> i replace the o2sensor but the check light is still is on..i believe its a vacuum leak but i dont kno nothing I found this On-Line ...

...Impala 3.8L. It turned out to be the MAF sensor located between the Throttle body and the Air Filter. The MAF can be cleaned, and parts stores will have a special spray cleaner for MAF sensors. It is ...

impala 3.8 3.8L EngineTo Remove: MAF Location Disconnect the battery ground cable. Remove the fuel injector cover. Disconnect the mass air flow (MAF) sensor electrical connector. Remove the MAF sensor

Impala with 3.8L. I had a similar problem with mine. As I recall, mine would idle OK, but would chug and buck like crazy on acceleration. Note: I had NO check engine light! I tried a new coil pack. No

...Impala ls 3.8l. Had been running rough and dying. Even at freeway speeds of 60+ Had complete tune up, new EGR valve and the MAF cleaned yesterday. Picked up at the shop got 4 blocks away car died and ...

02 impala 3.8. MAF input low. Pig tail? try to clean the maf sensor with alcol be very careful and gentle on maf film in the middle of air stream

...impala starting but stalls out quickly as if not getting gas Try unplugging the MAF sensor. It is located on the top of the throttle body. It should have a three wire connector. If the car now starts ...