Questions & Answers for: ign module

...module type, then the IGN B+ would be one of the wires going into the module. To verify, a DVM would be effective. This would also display if the IGN B+ goes down when cranking. When where the IGN B+ ...

...while someone cranks motor,be careful of moving parts,if it starts change ign. module in dist. if not check cap rotor,coil and power to ign.module,if theres power to module my bet would be on ign. ...

...Ign Coil/Module. Replace the Ign Coil/Module and the Problem should be Corrected unless the Rings are Worn Out. Operate the Unit until it Quits and then Check for the Plug Firing. If the Plug is Not ...

...driving for 1-2 hours. let it sit for awhile restarts. replaced cap,rotor,ign.coil,and ign. control module. 1989 cougar 3.8liter. no codes. distributor???????? You replaced module in the

...ign. module control ign. pulse The pulse comes from the magnetic  pickup in the distributor,Then the module "prosesses" the information and fires the coil .don't think you can get a module ...

...make sure they are'nt blown, then check for power to ign module which is under the coil paks, should be pink wire. good luck...sounds like maybe your ign module or crank sensor may have gone

...replaced with a no chip ign what problems are there if changing ign types a No start problem will occur the body control module has to have the original key with proper resistor chip to start the

how to test senors 02 olds alero 3.4 put in new ign module back fired now no start car did run before in stalled new ign module Did you get the spark plug wires back in the proper position?

...First, check for battery voltage to the injectors. If you get voltage but no ground trigger, then check for good crank and cam signals at the ign module. If you see those, then the ign module is ...

where is ignition control module on 2004 ford explorer There is no separate IGN module. The function is built into the PCM. The PCM is what controls the IGN coils