Questions & Answers for: hyundai transmission schematic

...transmission? The inner shaft goes into a small square housing and then a shorter shaft goes from there to the trans axle. Does it disconnect from the first housing or from the trans axle? Is it held ...

...Hyundai Accent 2004 1.6L goes all the way up (to the red line) and stays there for a while and then it just drops do completely cold... fans are working fine n engine is not overheating, no leaks, ...

...transmission but the electrical schematic is hard to interpret. Suspect an electrical control problem rather than a wiring issue. Any suggestions for beginning troubleshooting? replace the brack ...

...hyundai elantra Sport GLS - TCM. New AB sensors were installed but did not solve my shifting problem. I suspect they may have been connected backwards. Right now, PulseA is connected to the black and ...

transmission pressue control solenoid, so I need a schematic for a 1999 Hyundai Elantra, or can any one help with the problem at hand? dont replace parts till u kno the answer--thats an older trans so

P0890 CAME ON WHEN BRAKE LIGHT BULBS BURNT OUT code p0890 refers to transmission control module (TCM) power relay-sense circuit low==causes wiring short to ground TCM power relay--TCM. Check the ...

...hyundai excel I have chad the little motor for the wiper changed twice yet I still have a problem and the wiper motor get very hot Sounds like you have a hot wire grounding out somewhere. If you ...

...Hyundai santa fe won't shift higher than 3rd gear I would venture that it's your torque converter solenoid. I am fairly certain that is what it is. You will need to look at the Haynes manual or a ...

...Hyundai Sonata 4cyl. won't start in park but will start in Neutral. Any suggestions? Safety/neutral switch will cause that, Nicely done Michael, That's pretty much all the trouble shooting... $18 to ...

...Hyundai santa fe v6 automatic transmission and it dont want to go into drive it goes on reverse tho i have change the input and output sensors also the transmission solenoids and its still dont gonin ...