Questions & Answers for: how to hook up bulb for

...hook after installing a H4 HID bulb When I figured that my car's headlights are too dim for the roads, i changed to a HID-Style Halogen, sometimes fitting the bulb in was such a pain, because the ...

...spring that goes over the bulb into a hook shaped clip or are there 2 clips i feel your pain i have an 02 sonata and the clips are a bear. i use a small screw driver rather than my fingers. good ...

...bulb goes to the only fitting left to hook to at the carbruetor. you have 2 different length fittings on the primer bulb itself the longer fitting is your return line hook it up to your tank side and ...

...bulb into the lens. That clip has a small screw on one side and a hook on the other that latches into the lens. Press the hook in and move it up or down (it varies by car) to remove it from the slot. ...

...bulb in, and it slips under a hook on the upper leg. the lower leg doesn't have a hook. Depress the wire to free it from the hook, and rotate it back out of the way.4. Withdraw the bulb from the ...

hook, be sure to note the position of the plastic socket that the bulb plugs into as it only fits one way.Notice the tab on the bulb base faces up. The bulb does not fit snugly in the headlight socket

...taillight towards outside of van. Don't break hook(tab) on the light assembly. Squeeze the tab on bulb pull bulb straight out. Check hook grommet on van. Replace if cracked can cause water leak on ...

my 98 accord coupe dash lights are not working all fuses are good didnt seeany burning on circuit board it happened due to dimmer switch from after market cd player alpine was hooked up after un ...

...bulb. Usually there is ONE end hooked onto another 'Hook', it may be hard to see as well! This will SWING out, one side of the wire hook will stay in place DON'T PULL just move it to the side, like a ...

My husband hooked my tanning bed up to 220 and it's a 110 and now he hooked it back right and 4 bulbs are out on bottom and only 4 bulbs work on top how do I fix it This will most likely be as simple ...