Questions & Answers for: Stanley hold my hand

hand remove two pins that hold valve together and remove inner plunger. The middle oring on plunger is cause of leak. Try using an oring about same size as the broken seat. It must fit pretty tight to

...at www.bostitch.com, cost is about $20. To examine the valve, remove nails, remove retaining pin holding trigger, remove one or two pins holding tva6 valve (the pins holding the valve are in the ...

...hand drill. It may be quite old, but it works well and I like it Today, however, it shed one of the three small springs which hold in place the three vaguely triangular grips, for want of a better ...

...Bostitch TVA6 Trigger Valve Kit FOLLOW closely, take a small pin punch and knock out the pins holding the trigger in place and then the 2 pins for the valve, one is probably longer. Next get a ...

Hold the gun in your right hand The clip shield is spring loaded, when it released it will move toward base. Near the base of the hand grip on the left side there is a metallic clip, free it with your

hand remove two pins that hold valve together and remove inner plunger. The middle oring on plunger is cause of leak. Try using an oring about same size as the broken seat. It must fit pretty tight to

...may not include all orings needed. To replace the trigger valve, remove nails, remove the rollpin holding the trigger with 3mm driver to expose the trigger valve. Next remove one or two roll pins ...

How do i change the blade on the stanley box cutter fat max? Push the blade out as far as it will go and hold in the button on the side while slideing blade in and out.

...hand thumb and forefinger. 2. Hold the metal casing right beneath the black handle, with your left hand thumb and forefinger. 3. Use your left hand thumb and forefingers and a wedge to ...

...are usually stamped with model number on the lower body just above the nose piece on the left side (holding gun with right hand). Sometimes this stamping is covered with paint or the number was so ...