Questions & Answers for: Chevrolet S 10 how to fit a hands free kit

no pedal on brakes have bleed the brakes and changed the master cyclender did you replace the master cyl with a brand new one or second hand it is a second hand one the seals inside can be weak and ...

Ad

...at the master...some have bleed screws...ones that don't can be done by just breaking the line fitting and pressing down on brake gently, closing the line or bleeder while still depressed. ...

Ad

what other engines can be used in a 84 S-10 blazer besides the 2.8 V6? A 4.3 V-6 will fit, going to a V-8 tyou may have to change out tranny and all mounts the 4.3 will fit with the right mounts also ...

...hands on a Haynes auto repair manual for your car wish you the best of luck Michigan Man. do you mean the flexible connection if so this is easy ,just remove the feed connection ,then the lock nut if ...

...kit port only fit the port on the accumulator. I assume this port is the high side port and not the correct one. The recharge kit port does not fit the port on the tubing line. The port on the ...

...kit will only fit the low pressure line so that takes some of the danger out of the problem as long as you watch the gauge that is attached and don't over charge the system. Most likely these lines ...

Question about 1984 S-10

1 Answer

...fit a Small Block V8 into an S-10 with a little bit of work. There is also kits for sale for this purpose as well as books on how to do it. Just do a google search for "S-10 V8 kit". If you do decide ...

Question about 1996 S-10 Pickup

4 Answers

...free the fittings. If its the rubber line the local parts store will have it on hand. If its the steel line you will have to cut and bend it to fit. Be sure follow the routing so as not to pinch the ...

Question about 1996 S-10 Pickup

1 Answer

...fit into a 1985 chevrolet s-10 without changing the whole front end dont know all the possibilties , iknow you can put a small block in it with a kit ,sure most performance places sell them or reckon ...

kit comes with the fittings that  fit over the ports on the ac lines.As for the blower, it could be the blower motor, the switch, or the resistor.  The resistor cuts down the voltage to slow

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...