...and and playback key on unit for 5 seconds , service status window appears and select service control menu and ok , at eeprom clear option press ok for 5 seconds, press menu and standby good ...
OK, BECAUSE I TOOK IT OUT, REPLACED IT, NO ERROR SIGNAL, RAN OFF FIVE VERY VARIED COLOUR PRINTS, EXCELLENT RESULTS. TRIED AGAIN NEXT TIME SWITCHED ON, 5 FLASHES BACK AGAIN. CAN'T STOP FLASHES, PRINTER
...this problem? Thank you very much. A7 says that the scanner information in the eeprom is corrupted. The scanner is the wrong type. You will need a shop to do the eeprom clear in the diagnostic
...EEPROM and printer driver are correctly set for single-sided printing but still it allways rotates paper through duplexe. Could it be sensor problem or jammed switch? Go to service mode MENU and #, ...
Question about PIXMA MP190 All-In-One InkJet Printer
...on the screen. This is EEPROM CLEAR 5. Press OK 6. It will show 0 INK COUNT 7. Press OK 8. Press the STOP/RESET button 9. Press the ON/OFF button 10. The printer won't turn off, but will "reset" ...
Question about MultiPASS MP730 All-In-One InkJet Printer
...full" ? press menu - copy - # Select TEST MODE. Select [8] PRINTER TEST in TEST MODE. Select 3. [EEPROM CLEAR]. select 0. [INK COUNT]. press the [OK] key press stop to cancell restart the ...
...Clear to return to Standby mode. The best solution for reset chip for samsung scx 4200 is to rewrite eeprom chip. With ponyprog u can rewrite and over internet u can find what to write in eeprom I ...
Question about MultiPASS F80 All-In-One InkJet Printer
...PRINTER TEST in TEST MODE. 4) Select 3. [EEPROM CLEAR]. 5) Select 0. [INK COUNT]. 6) Press the [OK] key. 7) Press the [Stop/Reset] key (returning to the state of 3)), and then press the [ON/OFF]
...EEPROM clear), and 3-1 (Purge flag) 5) When EEPROM clear (3-0) shows in lcd, press 0, then OK, then Stop then press the OFF button. Repeat the above from Step1 to step3 in step 4 this time reset the ...
...data error turn off power and remove power cord from wall wait about 10 minuts and reset power cord and turn on power if clear error code then ok and enjoy. if not need to reprogram ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions