position sensor; it's located on the driver's side on the upper side of the bell housing of the transmission. Codes will not show when scanned because since there's no signal from the cps the computer
...crank/cam position sensor. Good Luck you probably have a vacuum leak, get a gauge at autozone and see what your vacuum level is at idle and under load it should be 15+ also check fuel pressure, and ...
...Crank-Sensor" work, then not, then work again? Could that make the "check engine" light not come on? The VIN ENGINE CODE IS A "Y" (5.2) But The "CRANK-SENSOR" THAT CAME OUT WAS FOR A 1994 (5.2) A ...
...position) turn key off and wait 10 seconds and turn on again 5-10 seconds and repeat 5-6 times. If there is no fuel being pumped into the container you need to replace fuel pump. You hook up a fuel ...
...crank position sensor is located on a 1994 Oldsmobile cutlass supreme v6 3.1liter. assuming it's a 3.1 it's about 1/2 way up the block in the rear of the engineabout midway between clys.2 and ...
...crank sensor on a 1994 ford taurus gl What engine? 3.0 DOHC 3.0 OHV 3.8 liter Should be under crankshaft pulley. Here's where the crankshaft postion sensor (CKP) is located in each of the engines ...
Question about S- Tool J-37089 Crankshaft Sensor Adjuster Balancer Checker
crank position sensor location. i have the pulley off and dont see it by the crankshaft. crank shaft position sensor location. cant see it there "1994 Taurus crankshaft position sensor (CKP) location:
Question about 98 99 Chevy Lumina Monte Carlo 3.8 3.8l Fuel Injectors
...position (crank) sensor, on the GM 3.8L V6 engine, can easily be tested (to find out if it's bad ... The PCM (Powertrain Control Module=Fuel Injection Computer) will not pulse the fuel injectors. ... ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions