...Chrysler Sebring Oil pressure light The oil pressure light on my 2002 Chrysler Sebring stays on. Just had an oil change recently. No sign of any leaks and oil level is good. What could this be. Could ...
I have all the bolts off oil pan in 2002 sebring conv 2.7 engine but I cannot slide it pass the oil shaft, can you help thanks Will need to pull the engine
...Sebring. Changed oil pressure switch and now oil light comes on at stop. what could it be? 2.7 ? This motor has oil problems if not changed every 3000 miles. Put a chrysler filter on it and the ...
chrysler sebring. it's leaking oil To stop the leak it will have to be replaced and a speedy sleave will have to be insalled on the crank surface this is not a little job and should be taken to a shop
...chrysler sebring. Took it for a 15 mile test drive and the oil light kept flashing and the car made a ticking noise the whole time. Any ideas? It has 102,000 miles. Recommendation... Do Not purchase ...
...2002 chrysler 2.7 engine location of oil pressure switch 2002 chrysler 2.7 engine should be on driver's side right above the oil filter I meant to say the Oil pressure sending unit is under the ...
how much oil do i put in a 2002 chrysler sebring? 5 quarts of 5W30W with filter change
chrysler sebring 4 cylinder 2.4 dual overhead and the coolant is bubbling in reservoir. I have replaced hoses, radiator, radiator cap, thermostat and thermostat housing. There is no white smoke coming
the pressure should run (i.e. at idle, at a specific RPM). http://www.justanswer.com/chrysler/6jsof-chrysler-sebring-limited-dear-mechanic-2002-chrysler.html no spec but remedy for oil light coming on
Question about 2002 Sebring
where is the oil sensor switch located on a 2002 chrysler sebring sedan its on the back side of the engine block near the transmission
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions