cam shaft sensor How do you install and set timming on the cam shaft sensor on a 98 ford 4X4 with a 4.0? there is a tool to line up the sensor while at top dead center on #1 cylinder you put it on top
...ford ranger 2.3 liter 1994 ford ranger 2.3 liter has 2 coil packs and 8 plugs the intake coil wont fire and have replaced it and plugs and wires crank sensor or cam sensor ignition control mod is ...
...wire that goes to sensor the gauge moves I replace the sensor and nothing happens the gauge never moves. When you grounded the wire which goes to the sensor you produced a short to ground thru the ...
...1998 Ford Ranger, 3.0L. I changed the spark plugs, wires and coil and it still misses really bad. What else could be wrong? I have also change the EGR Valve after the engine light came on. o2 sensor ...
cam sensor is located in the topside of the engine, behind the manifold, near the firewall. it is held in by two mounting bolts. just remove the wire connector and the two mounting bolts. you can then
...coil, plugs,maf, master sensor,codes read o2 bank one lean , o2 bank 1 rich, cat is clean had it checked and no one has a clue The timing chain has slack in it,or the cam sensor is the
Question about 1998 Ranger SuperCab
...1998 ford ranger 4x4 has like a skip and iv replaced the wires plugs and oxygen sensors but that didnt help plus it spits back through the filter area so what could that possibley be had similar ...
Question about 1998 Ranger
1998 ford ranger xlt 3.0 auto/ac 2wheel Now have clickingsound. I know probably push rods. But do u need to replace rocker, cam, cam followers at the same time. have it checked out professionally as ...
Question about 1998 Ranger
...1998 ford ranger. now the temp gauge not working. any ideas!!! You may have disconnected the wire on the sensor.it's close the the thermostat.Check this out. 1995 ford ranger coolant temperature ...
Question about 1998 Ranger
...cam sensor , coil packs and ignition switch also fuel filter Did you check for battery voltage to the coils ? Check for control from the PCM - engine computer . You probably should take it to a ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions