Questions & Answers for: change alternator 2001 mercury sable

mercury sable 2001 duratec engine DOHC I get check engine light and diagnostic code PO401". Any suggestions? "mercury sable 2001 duratec engine DOHC I get check engine light and diagnostic code PO401"

cps location 2002 mercury sable The crank sensor on the 2002 DOHC engine is located just under the alternator and you can change it but you have to get at it from underneath the car.

...on spark plugs for a 2001 mercury sable Check this 2001 Mercury Sable 3.0 liter V-6 DOHC VIN "S" or 2001 Mercury Sable 3.0 liter V-6 VIN "U" Hope this helps (remember to rate and comment this

2001 mercury sable 3.0 24V DOHC engine light on. PO171 and PO174 codes/ Engine at idle kicking down. Is there a vacuum leak in or near the PCV lines I have the same problem few days ago, and still ...

...mercury sable i have replaced the alternator and battery both new and it still will not charge it has a 3.0 dohc Check for power on both sides of the mega fuse located fuse block in front of engine ...

...2001 mercury sable with a 3.0 dohc engine. When you start the engine it misses and runs rough till it warms up, it then runs fine Run the codes,change spark plugs,clean the MAF sensor and always make ...

Will a 3.0L DOHC Duratec 30 V6 from a 2000 Sable fit in a 2003 Sable? how do i change my DPFE sensor on my mercury sable 2000 .

...2001 mercury sable LS 3.0 24v DOHC All Mercuries in 2001 were shipped with a label affixed to the inside of the engine compartment, listing FIRING ORDER, spark plug gap, and vacuum routing. Find the ...

...change the battery and alternator,now battery light want go off. This is generally caused by the either a wire wasn't installed or fastened to the alternator or the wire coming from the alternator ...

2001 Mercury Sable. PCV valve location on it please? Where is the PCV value located on a 2001 Mercury Sable 3.0 DOHC. How do you replace it. Question edited for a lot more clarity. Question moved to ...