Questions & Answers for: bypassing low pressure ac switch

...low pressure side 60 high side 200, centre vent temp 60. replaced new compressor same issues. compressor is not cycling long enough which switch is defective and how do you test with out changing all ...

...used tokeep your ac from freezing up i believe. i think that the problem is your A/C needs more freon134a it seems that when it has run for sometime the pressure gets too low and cuts out the LP ...

...you can bypass the low pressure switch located on or near the receiver dryer it has 2 wires plugged into it take a paper clip and bypass the 2 in the boot and it will run long enough to re charge

...low pressure switch or even a bad compressor. By pass both pressure switches one at a time with small wire or a paper clip. If comperssor kicks on replace the swich that you bypassed. if not it could ...

...low side pressure, you can bypass the low pressure switch by removing the connector and placing a paper clip across the terminals in the connector. If this allows the clutch to engage, charge the ...

...low side pressure switch with a paper clip at the connector. You have problems that this will not solve but good luck. This will do what you ask. If only knew what make model and year car you were ...

...low pressure cutout for your ac unit. this is a common cause of the ac compressor not running. You can test the compressor by removing the plug and installing a paper clip. This will bypass the low ...

low pressure AC cutout switch. 4. Unplug the connection and cross the two wires together with a paper clip or small cotter pin. This will bypass the low pressure cutoff. 5. If the AC runs continuously

...low pressure causing the compressor not to run, you will need to flush the system after eliminating the source of the leak. If the a/c compressor has never been changed, it is probably the source of ...

...bypassing low pressure switch with a paper clip in the connector. If pressure is good but bypass works, you need a new pressure switch. If pressure is low, charge the system. If pressure and presxure ...