Questions & Answers for: brake press

...press on the brake. Make sure you are replacing the correct bulb. You may have been replacing the bulb that stays on. Your lights may be set up to turn off the light that stays on when the headlights ...

Ad

...press the brake which is normal) because i am installing remote starter and it is not letting me program the remote(because there should not be any power without pressing the brake) need help thanks ...

Ad

Question about 2008 Rogue

1 Answer

...press the brake pedal then your gear shifter lock solenoid could be bad and need replacing. If your brake lights do not light up when you press the brake pedal, then your stop/brake fuse is probably ...

Question about 2008 Rogue

1 Answer

...press in) and I checked the brake lights, they don't go on when brakes are pressed. It happened while I was attemping to replace the middle break light and used a voltmeter to see if there was any ...

Question about 2003 Land Cruiser

1 Answer

...press the brake pedal down to the floor for 3 times,, bleed the bleeder screw behind the tire.. position yourself closed to back plate of drum or caliper for easy bleeding work. when the bleeding ...

Question about 2003 Land Cruiser

1 Answer

brake slightly work when you press the pedal, but when you press it further it just like there's something that is blocking it. If you replace the wheel cylinders or brake calipers and did not

...press only Brake pads and rotors are relatively new. On the first press of the brake pedal, the pedal goes very low on each stop. If you press again right afterwards, the break pedal travel is normal ...

Question about 2003 Baja

1 Answer

...need to be pressed ,fluid will run through the bleeder ,then tight bleeder back and repeat the steps ,pump, press, bleed ,few times per each brake caliper ,don't forgot to add fluid to the ...

...brakes hardly at all Can not press down the brake pedal and it has no braking power when applied what little bit you can press in in Check the brake fluid. If that is OK, the brake servo is

when you press the brake pedal? If not, the issue is probably a dead battery. If the lights are coming on, it is probably a defective brake switch (which tells the car when you are pressing the brake)

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...