Questions & Answers for: anti skating weight

...skating and jumping, especially if you use the turntable as a DJ. For example, vibration (caused hopefully by dozens rocking to your music). DJs will often increase the headshell weight very slightly ...

...anti-skating problem Pulled my turntable out of storage (8 years+-) and now the ant-skating is pulling hard enough on the arm that clicking the cue sends the arm to mid record. I have turned down the ...

skating properly? if so, how do you fix that? Hi the pennies will mess up the stylus. There should be an anti skate setting at the back of the turn table, a round adjustable bit with numbers, increase

the stylus will mistrack). Now try the deck again. You might have to make adjustments to the tracking weight again so whatever you have it set to, set the anti-skate to the same! Good luck with it (:-

record; doesn't engage grooves stylus "skates" across record when turntable is turned on (new at-lp2D-usb turntable, just assembled). Increase the weight of the arm, check if it has anti-skate control

...and tone arm hight on my turntables what are the proper specs, thanks. Anti skate should be set the same as the weight, i.e 3 gram of weight = 3 on the anti skate. ...

...combinations to no avail. And as I said it does this on some records throughout others just a certain points and others not really at all. Thanks Not enough weight and turn your anti skate

...anti skating weight.it prevents the grooves on the record from pushing the stylus inward,wearing out one side.when the anti skate weight system has a fault,it drags the arm toward the center of the ...

...in you finger a bit. 2 Has the weight on the end of the arm become lose? Adjust for the correct tracking weight of the cartridge. 3 Check the manual for what the anti-skate control should be set

...weight" on the arm (at the opposite end from the needle). Release the tonearm, you have to turn the weights untill the arm is in balance, then turn 2 and a half so that the needle will go down (2.5 ...