Questions & Answers for: 2004 jeep laredo high oil

JEEP GRAND CHEROKEE LAREDO 1999 WHERE IS IT LOCATED AND IS THERE A DIAGRAM OR PICTURE LOCATION FOR IT ANY SPECIAL KNOWLEDGE TO PUT IN? it should be right next to the oil filter which is passenger side

jeep cherokee laredo with an in line 6. The oil pressure gauge shows sudden oil pressure loss, but the the gauge recovers. Is the oil pump going out? the 1st thing u do is have the oil pressure tested

2004 Jeep Grand Cherokee Laredo? If the oil pressure is good and there is no engine noises then the oil pressure sending unit is the problem.Just replace it and you should be good.Hope this helps.Good

jeep grand cherokee laredo 2-wheel drive 4.0 litre engine the 1st thing that needs to be done is have a mechanical oil pressure test gauge hooked up to confirm the actual reading, the electronic gauge

Jeep Grand Cherokee Laredo and My oil pressure gauge goes to the H then when i stop i goes to the middle. Is this bad? Not really , when you give it gas it creates higher pil pressure at higher engine

I have a 2002 Jeep Grand Cherokee Laredo and My oil pressure gauge goes to the H. Is this bad? How many miles? How many starts and stops? Are you using too high of a viscosity?

...2004 Jeep Cherokee Laredo. An indicator (with a symbol of what looks like a radiator) below the low fuel indicator (bottom left had side of the dashboard) lights up and remains on. I have checked the ...

...Jeep Grand Cherokee Laredo my oil pressure is reading high on thethe gauge I'm wondering is this due to a badbad o2 sensor I put in new spark plugs and changed the oil what could it be Oil ...

2004 jeep grand cherokee laredo. its throwing a p1762 code and i have replaced the following: governor pressure sensor and transducer, internal trans wiring harness, external harness underhood, wiring

2004 jeep grand cherokee laredo turn signals wont work and running hot while standing still two reasons fuses blow, one circuit shorted out to earth, two load to high for fuse rating, to repair number