hp 220 volt submersible well pump when the commercial power goes out. Recently I had to replace the pump because the motor failed and I think the generator may have been the problem because one of the
10 gauge now and it gives a few good starts then it trips the breaker switch. It is a 208 - 240 volt 3.7 hp motor, (240/15/1). you need to run this compressor on a cooker trip (ei:30 amp) it pulls far
Question about 2 Hp Spl 3450rpm M56 Frame 115/230 Volts Replacement Air Compressor Motor Electric Motor No.B381
...HP Speedaire horizontal tank compressor is rated 115 / 230 volts at 24 / 12 amps, respectively. This means at 115 volts, a 30 amp circuit breaker is the bare minimum. That also means that the wiring ...
Question about 2 Hp Spl 3450rpm M56 Frame 115/230 Volts Replacement Air Compressor Motor Electric Motor No.B381
HP 240 v motor look on the motor face plate for its F/L/C/full load current rating,and go by this,otherwise to be safe use 2 # 10 AWG for the 240 lines L1 and L2 and a #12 AWG for the Neutral line and
Question about Rand Single Stage Cast Iron 3 Hp Air Compressor - 60 Gal., Vertical
...hp IR commpressor? What size wire, what size breakers, and where on the motor do I attach my wires. Motor says 15 amp, 220 volt. Thanks, Clint I would use a # 10 wire size with a 30 amp breaker. The ...
Question about Rand Type - 30 Reciprocating Air Compressor 10 Hp, 460 Volt 3 Phase, ModelNo. 2545E10FP
BREAKER IS KICKING OFF Has this unit just been installed or has it been running. Just installed check wiring. If been running check wiring for tightness on starter. Check voltage and amps. Compare amp
Question about Rand Type - 30 Reciprocating Air Compressor 10 Hp, 460 Volt 3 Phase, ModelNo. 2545E10FP
HP, same service factor, same motor frame, same physical characteristics. That is the kind of motor I would use. Your existing motor name plate states characteristics of the motor. Find the MOTOR name
Usually answered in minutes!
317 Questions
162 Questions
122 Questions