Kenmore 665 Ultra Wash FH141493

How many times does it blink before pausing and repeating? 7 times? (That's a common problem - means "water not heating" error.) In some dishwashers, instead of pressing Heated Dry, Normal Wash, Heated Dry, Normal wash, you press the 3 left-most keys in the following order: 1, 2, 3, 1, 2, 3, 1, 2, 3. That will start the diagnostic cycle and clear the error, but if you don't find and fix the cause, the problem will come back the next time you run the DW. But before I try to explain how to fix the root cause, I would need to know how many times the light is blinking.


If you need further help, reach me via phone at https://www.6ya.com/expert/ronald_e6b9572cebe3ad27

Press cancel. If the 4 hour delay is still lit, you have a shorted control panel.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/jeffrey_634abadf963e31e5

Have you unplugged wait for 15 sec plug back in. Might reboot.

Hi and welcome to FixYa. I am Kelly. The 4H is indicating your dishwasher is in the delayed wash start mode. Here is some information from Sears about what to do:

• The number letter combination indicates that the dishwasher is in a "Delay Start" mode, as well as how many hours were set for the delay start.
• The dishwasher will not start the wash until it reaches the delayed hour that it was set for. Example: 1H = 1 hour delay start, 2H = 2 hour delay start, etc.
  • To start the dishwasher immediately and not wait for the Delay Start time, cancel the "Delay Start" option, by pressing the Cancel button. Then program the cycle and options and press Start.
  • To start the dishwasher after the Delay time, select the cycle and options desired. Select the "Delay Start" option and on some dishwashers it requires, pressing the Start button.
  • Some dishwashers will display a countdown of the delay time on the display.

Note: Refer to the Owner's Manual or Use & Care Guide for specific instructions on using the "Delay Start" feature.

If you need more assistance we will need your exact model number in any of your future responses.
Thanks for choosing FixYa,
Kelly

The control panel is most likely defective, take it back.

- To clear the flashing light you will have to reset the console. Do this by closing the door and press these buttons in sequence...

-high temp wash
-heated dry
-high temp wash
-heated dry

there is no real way of checking the keypad. Not with a meter but if you push normal wash for example and it does not respond this usually means that you have a bad keypad

The 1 H is not a fault code it is the delay time of one hour.

key pad need to be change

dcvxzcxzcxzczxc