Cant figure out how to put the deck back on my lt 140 6 speed husqvana rider is there a diagram i can get please love this machine dont wanta scrap it

here is a diagram from the internet, hope it helps.

it's usually on top of the deck clean off the grass and look on top may have to remove it to see

You are going to have to pry them up with a screwdriver or other thin strong tool and see if you can see the tabs that lock it in place. Then take another screwdriver and push the tabs back to release them.

Good luck. If all else fails, scrap the hubcaps, you can use some Oops glue to put them back on if the tabs are broke.

have you lowered the feed dogs to do the stippling ie free motion embroidery??? If so you will need to renage the feed dogs, usually a slide at the front of the machine base or at the back of the free arm.

I would suggest taking off the foot, putting on the regular sewing foot, checking that the feed dogs are engaged, setting it back to a straight stitch setting. Then turn it off, wait 30 seconds and turn it back on and see if this resets it to normal stitching mode.

I have the exact same issue. Please someone help!!!

here is the free manual, hope it helps Tim:

http://cubcadet.custhelp.com/app/answers/detail/a_id/1722/~/cub-cadet-technical-service-manuals

ck flywheel key, also ck coil

check the linkage on the transaxle,It sounds like it may be out of alignment.

Most mower decks have the diagram on them, if not go to MTD.com and put your model number to see the diagram.