Roper top load washer spins but does not drain water and smells like rubber burning

The drive motor which spins the drum is connected to the drum by a rubber belt. Sounds like the belt is burned through. Make sure you can spin the inside tub by hand to verify that the tub can turn freely before you replace the belt. The hum is from the drive motor just spinning freely.

If you need further help, reach me via phone at https://www.6ya.com/expert/steven_a67ead41eb5fc62a

Fixya needs a model # for us to help. Thanks

Known problem:
A Failed switch Ark-Les part #8318084

Incident report on there website:

I have a Roper model #RAX4232PQ0 top-loading washing machine. The door switch wore out, short-circuited, and caught on fire. The machine continued to operate, so it took a little while to figure out where the smell was coming from. The failed switch is an Ark-Les part #8318084.

if the washer drains the drive cuppler it bad let me know if draing can walk you threw how to replace

the washer needs to have the lid closed to go into spin cycle the lid switch is broken just replace it and that will fix it

Hi, it is possible that something got into the pump and stopped it from turning. Let the drain hose down so that it drains into a bucket or a floor drain if possible.
If water does not drain then it is deffinetly plugged. Once you get the water out of the washer, tip it against the wall and try to remove the pump off the motor. There are two clips that hold the pump on. You will also need to remove the hoses.
With the pump off, you can set the washer back down and try to run the spin cycle. If the motor runs, it must be the pump.
Please let me know if I can assist you further.
Thanks
Vic

Its sounds like the pump has frozen, If your smelling the belt burning its either that, the tranny binding, Or the tensioner has a defect (very unlikely). If its washing, agitating and spinning okay its the pump. Get ya a new belt while your at it!

sounds like a belt problem. if you're not smelling burning rubber (belt) either the belt has come loose or broke

faulty drain pump no drain no spin

Pull drain plug at bottom of machine put tray under it check belt