177 Fatal Error - Xante CL30 HSE Laser Printer

177 is a thermistor problem within the fuser. Just replace the fuser to cure the problem. Remember to replace the fuser with the power off.

i have a isys iterra elite II printer showing a fatal errror:131 pls wat does it mean

b0605 on hp laserjet p2055 connected to the network ...how do i sort this out ...khathu

F4 Shorted oven sensor (RTD) Check for shorted wiring between EOC and RTD. Check resistance of RTD using resistance table. If resistance test is correct and wiring is good replace EOC TEMPERATURE °F RESISTANCE ω 32 ± 1.9 1000 ± 4.0 75 ± 2.5 1091 ± 5.3 250 ± 4.4 1453 ± 8.9 350 ± 5.4 1654 ± 10.8 450 ± 6.9 1852 ± 13.5 550 ± 8.2 2047 ± 15.8 650 ± 13.6 2237 ± 18.5 900 ± 13.6 2697 ± 24.4

lift your top cover up and check the ribbon cables to the black leds (4) under the cover 2 on each led, these have been known to be loose and cause those fatal error codes

A 177 is a fuser code. The fuser is the part that gets hot. Try rebooting the printer. Try taking it out and putting it back in (with the machine off). You might need to replace the fuser unit.

I think that's a buffer overflow error, but if you get that error no matter what you print I would check to make sure your memory isn't bad.

From OKI error log:

Lower heater temp state - Low
backup roller thermistor indicates low temp
seek service if turning off/on printer does not solve problem

177 - Replace fuser

Replace fuser unit, just slides in, you can do it!

LINK to purchase Fuser as shown below

.