The cold water just trickles out. - Roper RAS8445KQ Top Load Washer

CHECK AND SEE IF THERE ARE SCREENS AT THE WATER VALVE IT MAY BE CLOGGED THERE

sounds to me like the hot water solinoid is faulty

Assuming the supply water pressure is ok and the screens are fine replace the water valve. http://www.appliance-repair-it.com/clothes-washer-repair.html

Sounds to me like your inlet valve is gunked up. You will need to replace your inlet valve. I would also check your hoses first to make sure the cold water hose does not have a screen on it that is full of calcium deposits. Hope this helps _MJ_

remove the cold water hose from the machine that is your service line feeding into it.
a screen in the inlet were the hose attaches to is probably clogged up

Assuming you have good water pressure to the inlet valve, you probably have a blocked or faulty inlet valve...Not a big job....Good luck...Nomess

Hi, You need to remove the fill hose and see what is plugging the inlet valve screen. This should make a guge difference.
Please let me knwo ig I can assist you further.

Thanks
Vic

Sounds like cold water solenoid is not opening all the way, its easy to replace, and is found inside the wash machine where the hose connects

i believe on the water valve where your hoses connect,they have screens or filters inside maybe it is plugged

turn off water valves at wall, disconnect the supply hoses from the washer. where the hoses connect to the washer, there is usually a stainless steel screen/strainer inline on both the hot and cold inlet. corrosion on the cold side is pretty common. Menards, Lowes Home Depot stores sell the replacment screeens.