Trim tilt guage not working,2000 model 70 hp Johnson outboard.thanks Peter.

Check this thread on removing the tilt trim from your 1998 50hp Johnson motor: https://www.thehulltruth.com/boating-forum/490732-1998-johnson-50-hp-trim-tilt-repair.html

need model number

To get the year of Johnson and Evinrude outboards use the word "INTRODUCES". Each letter corresponds to "1234567890" respectfully. It's best to check with a model year reference book, but this motor's model number contains "CC" which would indicate it's a '88.

Did you try E to aux and x1 to c. Good luck

WWW.OVERTONS.COM ORDER A SELOC SHOP MANUAL

on the right side of the motor there is a lever that says tilt on it pull it up unlocks motor grab the top of motor and pull with all your mite

Make sure there is not a spring loaded locking lift latch engauged. If there is you will see a little movement and then the motor will sound slower. If there is no movement and the motor runs the same speed with no change you are low on hydraulic tilt and trim fluid.

Please take a moment and rate my answer............ Thanks

Ihave a 1991 70 hp Johnson outboard thats hard to start the first time but starts good after that. Seems to be flooded. Starting rpm seems to be low.