Dummy holes in flat panle

agree with a small hole trick... but don't leave the drive ever empty. Use i.e. dummy CD media always. When you need it, just replace, spin your DVD, than put DUMMY back in the drive. Don't believe? Just try. :-)
proizvodnja raunara prodaja laptopova popravka kompjutera pc servis...

Probably the power supply have some problem. check the link bellow to understand how to check the power supply of a flat panle tv.
Testing LCD TV Power Supply BoardsSTEP BY STEP
www.electro-medical.blogspot.com

The problem post of yours' has no sufficiant details to place a solution. Provide more details please. google.com/+GopakumarGopalan

Hello. Welcome to FixYa. Please allow me to help out here.

Yes, there is a hole under the wiper motor. This is where the heater/defroster gets fresh air from.

If you are getting water in the heater box, the drains that keep the water from backing up, and entering the hole, are blocked. You will need to have the cowl panle removed, and any debris under the cowl removed and cleaned out.

You will need to remove the interior panle from the loft gate to axess the latch
there is 4 screws along the bottom of the panle to remove then carfuly pull the panle away from the lift gate there is plastic clips that hold the panle to the gate these may need to be replaced when re installing the panle they can be purchased at the jeep dealer.
now look into the lift gate and you will see where the handle rod conects to the latch lift on this rod and the gate will open
to replace the handle remove the 2 10 mm bolts and disconect the rod from the latch install the new handle and rod to the latch install the 2 10 mm bolts. install the panle and 4 screws
this should cover it

Check the factory door drains at the bootm of the door. Should be 2 slotted holes at each end of the door make sure they are open. Sometimes they have plastic inserts in them just pull them out. The other way would be to remove the inside door panel and vaccum it out. Or drill 2 holes but that might make your door rott over a peroid of time. The door is tappered to drian at the slotted holes.

Hi, You will need to remove the rear panle inside the freezer section. You will find ice built up over the defrost drain hole. Remove the ice using a hair dryer (not a heat gun & nothing sharp!) Oncel the drain hole is visible, try and flush it out with hot water to be sure it is open.
I hope this helps you, Please let me know if I can assist you further.

Vic

Normal 0 Quite simple. Disconnect your negative battery cable. Locate and remove the screws that hold your interior door handles in place (they may be hidden by snap in, or snap on clips). Remove the interior door handles, then disconnect the wire clips to the switches. Your panel is held in place by snap in clips; use a small pry bar to pull them from the door (try to get as close to, or directly under the clips to prevent them from tearing out of the door panel). Once the clips are pulled, pull the panel upward to remove it from the door.
Install in reverse.

there should be 2 drain holes. 2" from the edge of the door. it is a **** opening just above the outter door weld.

There are no speakers on that monitor. Those are 'dummy' holes.

There are no AUDIO IN jacks on the back either.