Signal goes in my area - Motorola Mobility MOTORAZR2 V9 Cellular Phone

New telephone company procedures in many areas now
require that all 10 digits be dialed even for local calls --
Area Code + Exchange + Number

Perhaps your Directory listings do not include the area code ?

Good luck!

If your signal keeps breaking up , you might be in a poor reception area , Check if you get the same problem on other DAB stations you are tuned into.

These are usually right around the crankshaft pulley area. They pickup the signals from the front of the engine where the fanbelt goes around the lower pulley. The sensors are usually pointed towards the crankshaft right in that area of the crankshaft pulley.

Your in an area that doesn't have a good enough signal. Either your service is giving a low signal, or your wifi is. Have you tried doing a reset on your iPad? That sometimes helps.

On-Air RF signal strength is too low at your area. Try using a signal booster. Gopakumar Gopalan Google

You found it. and you verified it the solution and the fix is the turn signal switch

check voltage from brake switch to signal light switch, signal goes from brake pedal to signal switch then to taillights, i suspect the problem is in that area

Hello,

I don't think this is a phone problem.Bad signals is caused by network provider or probably you are in an area where signals is poor. But i don't think its a phone problem. Try leaving your area and go to another area and see if the problem still persists. Then you could see a Blackberry technician.

Best regards

turn on turn signal switch to which ever side is workimg and listen for the switch clicking. they put them under the dash in many differant areas and are hard to find unless you can hear them click. try this and see how it goes

Whistler 1730
Turn it on: goes through all set ups: But does not pick up any false or any radar signals at all????? All buttons work: all right beep sounds work :but no signal pick up at all?????