Need instructions to program and operate my Omega Excalibur K9 car 3-button remote entry.

Thankks for posting your question here in fixya! ;)

HERE is the link for the manual to help you with the programming of your alarm system.

The K9-Eclipse has a push button valet switch. The switch is about 1/2" in diameter and about 3/8" in height. I can be installed anywhere but it is usually under the dash.
In order to activate valet mode, you need to push and hold the button for 3 seconds while the system is disarmed. Valet mode will be confirmed with a long siren chirp and the LED illuminating.
Valet mode can be deactivated by pushing and releasing the button.

You can contact Omega Research and Development, the makers of Excalibur and K-9, for a local dealer. Omega R&D website

Is the LED indicator illuminated steady (not flashing)? If it is, than the system is in valet mode. In order the turn off valet mode, you need to press and release the valet button once. The LED should turn off and you will be able to operate the security system.

Use this procedure to reprogram the remote transmitters

1. Turn "on" the ignition.
2. Press the Valet Switch 5 times and wait for horn confirmation of entry into programming mode.
3. Press and release the "Lock" transmitter button on each remote to be coded (one at a time).
4. The system will respond to each with an audible confirmation.
5. Turn "off" the ignition to exit program mode.

The unit should retain the transmitter codes almost indefinitely and should not require reprogramming periodically. I suggest that you call Omega Research and Development, the makers of Excalibur, to see if your unit can be replaced. Their number is 800-554-4053 and their is www.caralarm.com

Turn "on" the ignition, then press the valet switch 5 times and wait for siren to chirp.
Then press and release any button on each controller, one at a time.
The system will respond to each with an audible confirmation.
Turn "off" the ignition to exit program mode.

Try to reprogram the remotes to the alarm. Have your vehicle key and both remotes ready. The way to do this is as follows:

1. Turn ignition key to run position.
2. Within ten seconds push the valet button 5 times.
3. The siren will give a chirp, indicating that you are in programming mode.
4. Press the large button on the first remote. A chirp will be given as confirmation.
5. Press the large button on the second remote. A chirp will be given as confirmation.
6. Turn off ignition and remove key. Alarm will give long chirp indicating exiting program.
7. Try remotes. Both should be working.

For the next 48 hours, every time the vehicle is starting the siren will chirp indicating that remotes have been programmed. After 48 hours this feature will turn itself off. Also keep an eye on the alarm light as it will also blink the number of times as remotes are programmed every time the ignition is turn on.

Hope this information helps. Please rate. Thank you.

can you be a little more specific. Are you talking about a remote starter???

turn key to on position, push valet 5 times then alarm will chirp then hit the lock button on remote

turn key to on position push valet 5 times then hit lock on the remote