Rival Chocolate Fountain CFF5 - never used and motor does not work

May be time to experiment but try googling cake recipes first or chocolate cake recipes or any word combination you can think of - I can guarantee you will find an evening of interested reading and find a host of cakes you will want to make...

Check on Google " how to download ...... " also try using Google Chrome instead of Internet Explorer

Google Hobart --utube-ebay has 300 4sale somebody might know something--waiting on the chocolate chip cookies

This plugs into a standard 120v household outlet, it's only 150 watts, running 10 of these is like one hair dryer. Most products say 110v, 115v in the USA.

The actual voltage is around 120v at the breaker panel and around 118v at the outlet.

But all products marked 110v, 115, 117, all work on a standard outlet.

Don't worry about the Worm Gear for now. You have to make sure that the Motor
is fully functional by itself: Remove the Transmission Housing Cover (4 screws) and
the two screws holding the Motor down. Lift the Motor off the Worm Gear and set it
on the side (be careful of AC voltages from the Motor and Control Assembly).
Select Stir setting and observe the motor shaft. Is the Motor running? If it is,
Select other speeds to see how the motor performs.
With the motor now fully functional, you can now check the Worm Gear Follower
for worn out/broken teeth. Remember the motor drives the Worm Gear, it then in
turn drives the Worm Gear Follower (you may have to remove the grease to see it)
The Bevel Gear sits right on top of the Follower and drives the Attachment Gear.

I have a solution to the dough hook problem for the Rival FPRVSM0001. I purchased some from the Rival website and my husband make a modification and they work great!! Made bread last night... SO happy! :) You can reach me at [email protected] if you'd like to get a set from me.

http://www.jardenstore.com/ProductsList.aspx?brandid=498&pgid=1128&sort=2&page=1

or contact sunbeam (rival and sunbeam have the same parent company) 800-458-8407

you can order the part here

http://www.crock-pot.com/CustomerService.aspx?id=rpt

Please what model of Kenwood you have ?
if is 901 press the green boton. inside when you up the head.
if with that not working. is necessary check the motor and change some components .

regards
Kenwood Chef Restore

Remove the shiny drip ring on the planetary, use a small screwdriver and gently pry it off. Remove the "Tapered pin" that holds the planetary on the shaft, gently use a punch and a hammer to do this. This pin can only be tapped out in one direction. Pull downward on the planetary assembly until it comes free. Examine the small gear and bearing for excessive wear, examine the ring gear that remains in the mixer body for wear. Clean and re-grease these gears if they look OK. These gears are in operation in any gear and as such, receive the most wear. When re-assembling the planetary re-install the tapered pin the way it came out. The previous solution will address the transmission gearing. Replace parts as necessary. Good luck. Please rate this solution if it helps you. ricardok45