Mpc 1000 I can not get my pads to work anymore which means i can't load anything either is there a pad lock or something?

double click on the top of light than in mouse pad

Have you loaded sounds for the pads from an internal or external storage device? (Such as CD or Internal Hard Drive, if installed) - each time you turn on the power, the programs are cleared so the pads will not make any noise until you load the sounds you want.

Otherwise, it could be related to your speaker setup?

Provide some details on your system setup and whether you are loading programs etc.

Simple way is MIDI out from Juno to MIDI in on MPC, then (depending on how you want to work), connect MIDI out from MPC to the in on the Juno. If you do this you MUST turn local control off on the Juno or else you'll get double triggers (internal + msg in from MPC). Now to record sequences on MPC , set MIDI to as track in setup window (on the 2500, this is accessed by pressing MODE then pad 9, then press button under the corresponding tab [on LCD]) then set your MIDI channel by port, meaning if your MIDI cable is physically connected to out A, in your LCD in bottom right corner it will show as follows: 1A. This indicates you are transmitting on MIDI channel 1; port A. Remember, MIDI IS NOT AUDIO!!!!! Since the Juno is a synth and not a workstation, all transport controls are handled by the MPC, that's pretty much it... Hope this helps a little, enjoy!

P.S. Go to mpc-forum.com its THE sh**! They also have links for their e-book I have one for the 2500 and its awesome!!!

Also if your ac adapter(powercord)is bad, the touchpad/mouse sometimes will malfunction and become impossible to use or not work at all.Start with checking your ac adapter voltage or try another charger first.

You have to go to the sample edit page and move the start point to the beginning of the wave sample. Right now your start point is before the sample actually starts.

Have you checked it out from the manual. If you have get in touch with www.akai.com and ask them. they are the manufacturer and YOU ARE THE CUSTOMER.
Good Luck

go here:

http://www.mpcstuff.com/pad-sensors-with-ribbon-for-mpc.html

there is also an install video.

i have the same exact problem.

best,
m

First ensure that you are saving into the right folder, on MPC HD and not into a subfolder, and that files are in correct midi format. Also ensure that connections to MPC are OK.

If connections and saved files are ok, then probably you need to reinstall Mpc 500software onto your computer, using disk provided with your Mpc 500.

You could set the sample to "one shot" in the trim page or in the Program>KG Mix>Zone page.... it is currently set to "as sample"... i like to use the release to let the sample fade out as long as i like... its a lot diffrent from the old poly mono thing but i like it better overall... hope this is helpfull.

Yep the paper feed roller wears and will need replacement (open front cover in centre of machine tabs on either side it just clicks out.

should also change sep pad (multi feeds)

Here in LINK to purchase items pic below