My Whirlpool range model W10182753b is not working using bake or broil. Was working a week ago. Could this be a setting? Nothing is on delay or timed cook.

Have you set the time clock for the correct time of day and made sure it is set for manual instead of auto (A)

Sorry but it could something as simple as a loose wire or a bad control unit. This is beyond the skill set for the average person.

you might have to run it through the entire self clean cycle.
Best regards
Ck

Oven suddenly stopped to work.
After trying to turn on "bake" or "broil" I can hear couple clicks but nothing else happens.
No flame/no gas is coming out.

the oven controller in the main service/selection panel has either a bad solder joint on the circuits or the start realy for the oven on the same circuit board is bad and you have to replace the whole panel you cannot just buy the relay

hi the part # is AP 3008287 at Appliance parts pros.com infinite switch controls the top burners thanks the appliance doc

hi thanks for the question . the control board seems to be defective the clicking noise is the relay .but not letting power to the elements thanks the appliance doc

Typically what happens on on these models, when the bake element breaks, it sends a surge back to the oven control (or clock) and causes it to fail also. Sounds like this is what has happened here. If the overlay (touchpad) is a separate piece, you will need to buy it also. Let me know if you have any questions.

Our Whirlpool oven just started doing the same thing!!!! The Delay Start Time (setting it for one minute ahead) and then Start works just fine.  But we fried the tops of three loaves of homemade bread!!!!
Is Whirlpool just a bad brand for ovens?

sounds like a wiring problem check your power source