20 Most Recent Whirlpool GS563LXSS - stainless Steel Gas Kitchen Range Questions & Answers

To Self-Clean Using AUTO-CLEAN 1. Press AUTO CLEAN. 2. Press the HOUR and MIN "up" or "down" arrow pads to set the desired self-clean cycle time. 3. Press START. The oven door will automatically lock. "CLn," "LOCKED," "ON," "CLEAN," the Cooktop Lockout icon, and the time remaining will be displayed. 4. When the self-clean cycle is complete "END" will be displayed, and "PUSH"/"OFF" will blink alternately. 5. Press OFF/CANCEL. "LOCKED," "END," and the Cooktop Lockout icon will disappear from the display. "PUSH"/"OFF" will stop blinking, and clock will show the time of day. 6. Once the oven is completely cooled, remove ash with a damp cloth. I hope this helps and thank you for a model number that made this possible for me to assist you. Good Luck I’m happy to help further over the phone at https://www.6ya.com/expert/gere_bf68e6055dd61249

You have a control board issue, this model has a lot of problems with the control board.

The oven electronic ignition is bad, very common, to replace remove oven door and the grate shelf, then unscrew bottom panel inside oven , you will see the ignition device towards the back unscrew it and unplug the the electrical plug to remove and replace it. I found them cheaper on line, like Sears parts center, it takes about 15 minutes to change out.

if the temp runaway error is shown, it could be the temp sensor. there should be codes displayed. these are needed to diagnose.

If this the first time the oven is used it is nornal to see smoke as the oven burner and racks are coated with an oil film to prevent rusting while in storage. Other than that look for something stuck on the burner assbly clean any heavy spills on oven bottom. On your next nice day open windows an turn on self clean cycle.

F5 is a fulty display control board. Unfortunately there is nothing you can do to fix this problem but to order and replace the display control board.Here is the board to order.

Hello,

The E1-F1 code is just one error code and it means that the oven control has detected a error within the control itself and the control needs to be replaced. The part number for the control that should be replaced is W10116542 it could be purchased at your local appliance parts store or online at;
searspartsdirect.com
apdepot.com
partselect.com
repairclinic.com
apwagner.com


GENE...OldTech2332

Hello,

The holes on the actual bake burner bar(tube) could be clogged so ya hear the gas coming out the rest of it, the spark cant ignite the gas since the gas isn't getting to the spark. If it hasn't been done the holes could be poked with a paper clip to assure their clear,or the burner bar could be replaced. If that doesn't fix it it's what my airplane mechanic friend would call a hanger queen and that plane will never fly.

Good luck,i hope this helps,
Gene