2006 Buick Rendezvous 10 Amp ABS fuse keeps blowing. What could be the problem?

Take the fuse out from the fuse box good luck colin

Fuses blow because there is an overload on the system. If the fuse blows when you step on the brakes then there may be a short in the wiring from the brake light switch to the lights, abs module or turn signal switch. If the fuse blows when you turn the key on then there is likely a short in the wiring to the brake light switch. Basically you will need a wiring schematic to check the wires at the switch and at each of the loads. Also verify that the fuse is supposed to be a 10 amp fuse. Hope this helps

You have a short some where in the wire from the fuse box

fuses blow from over current( dead short) they are rated at lower than what is required so that the wire doesn't burn
If you keep putting in bigger fuses without fixing the dead short, eventually the wire will melt the plastic insulation off and the vehicle will burn

Pull the electrical connector to the visors out of the headliner and disconnect it from both visors, see if the short goes away.

Unplug the fuel pump, and then with a new fuse,cycle the key on and off multiple times. If the fuse doesn't blow, you might have a failing fuel pump.

CHECK THE IPC OR INSTRUMENT PANEL CONTROL FUSE.LOOK FOR 10 AMP BLOWED FUSE.

It is possible that something(road debris) has lodged between your ABS sensor and the rotor fins that report to the ABS computer.

check the coolant level on the vehicle.make sure its full..if its not blowing hard inside it may be the blower motor gone bad