I have a CL code on my GE Profile Washer wpgt9150 what does it mean?

6871ER1003C New Factory Original LG PWB Main Assembly
LG 6871ER1003C MAIN PCB ASSEMBLY NEW ORIGINAL
New LG Main Assembly Pwb 6871ER1003C
LG Main Assembly Pwb 6871ER1003C Great DEAL
Genuine LG Washing Machine Main Control Circuit Board 6871ER1003C

"GE profile with stator base manual" see page 25 shows the fuse in the RF choke



If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

i own this model the main nut spins of sometimes and the brake becomes lose just tighten the nut it only takes about 3 mins

I think you mean, LE error code, as there is no nE error code, their codes display are strange.

Locked motor error. Cause: The connector (3-pin), male,white) in the motor harness is not connected to the connector. (3-pin,female,white) of stator assembly. Or the electrical contact between the connectors. (3-pin,male,white) in the motor harness and 4-pin,female,white connector in the main PWB assembly is bad or unstable. Or the motor harness between the stator assembly and main PWB assembly is cut (open circuit) Or the hall sensor is out of order/defective.

HI. This will be the cause of a defective PCB. This circuit board is the main controller of your unit. the clicking is the result of a failed relay assembly. these relays are mounted on the board, itself. The board should be mounted just behind an access panel, on the rear of the unit, slightly above or near the compressor assembly. Kindly have this PCB replaced, asap.

The PCB is , indeed, the culprit in this situation. Once the PCB is exposed, you should visually inspect for brownish discoloring, and relay trauma. Possible power surge may have caused the board to short.

I have a repair guide HERE

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

You have a bad transmition.
Please rate this solution

HI. the Main Pwb/pcb assembly(board) must be replaced in this case. there is a chip set failure that has occurred. The main board is inoperable at this time.

HI. this LCD is attached to the PWB assembly board. Unfortunately, this lcd is not sold separately and, you will need to replace the whole PWB assembly in order to fix this issue.This is actually a pwb(pcb) assembly failure.

CLICK HERE TO ORDER YOUR NEW PWB ASSEMBLY(LCD)

Possible Solution...
When you get message first try turning off. Open door spin drum one or two times. Close door. Power back on/start.
Works for our problem. Post if this helps.