GE Washing Machines - Recent Questions, Troubleshooting & Support

There should be a chrome label on the back of the machine, some times on the sides.


GE Washing... | Answered on Nov 22, 2019

If spins, pump problem. If no spin thats problem. Motor reversing switch bad, possibly bad v belt on the bottom.

GE Profile... | Answered on Nov 20, 2019

There's a part under the agitator that lifts off if you pull up from the bottom on both sides) called a coupler that is attached to the shaft with one bolt. The plastic teeth probably have stripped off from this coupler, causing the agitator to not agitate properly.

I would buy the part on amazon.
Here's the link to the exact part:

Video to show how:

GE Washing... | Answered on Nov 14, 2019

First make sure someone didn't turn off the supply valves where the washer hoses are attached to. If both are on, then try to fill machine and switch between hot and cold water. If one of the 2 temps works, the other half of the fill valve is bad. The fill valve is the part where the hoses attach to the back of the machine. It is a 2 part electric valve with 2 electric coils on the valve. Could be one coil is bad or possibly the filter screen is blocked on one side. Screens can be checked and looked at by removing hoses and looking inside end of valve. If coil is bad, complete valve needs replaced. Easy exchange, a few screws, 4 wires, and a small hose leading to inside of machine.

GE Washing... | Answered on Nov 06, 2019

Solved: There was a piece of fabric caught in the water drain pump. Opened the cap at the back bottom right of the washer and pulled it out. Worked fine after that.

GE Spacemaker... | Answered on Oct 28, 2019

remove fabric softner cup then deep inside 7/16 or 1/2 inch screw remove then remove plate then check plate with pin and screws can buy on amazon

GE Washing... | Answered on Oct 19, 2019

possible worn belt or bad motor

GE Washing... | Answered on Sep 28, 2019

check hose if ok check pump

GE Washing... | Answered on Sep 28, 2019

possible water inlet plugged or solenoid bad

GE Washing... | Answered on Sep 28, 2019

This could be a problem with the rotating spray arms which, of course, you can't see when it s operating.

GE Washing... | Answered on Sep 26, 2019

Not finding what you are looking for?
GE Logo

9,360 questions posted

Ask a Question

Usually answered in minutes!

Top GE Washing Machines Experts


Level 3 Expert

85216 Answers


Level 2 Expert

157 Answers


Level 3 Expert

411 Answers

Are you a GE Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides