Novotronic 7644C - The dryer is not completely drying and the clean out airways light keeps coming on. I have rinsed the filter and cleared all the lint screens. Also there is water leaking out of the bottom. Help!

There is help here for the various sensors

https://www.google.com/search?q=Miele+Novotronic+T7644C+moisture+sensor

..

The fluff filter may be
blocked.
Clean the fluff filter.
The vent ducting or the
ventilation outlet is
blocked.

my miele dryer keeps stopping and flashing a red light between the locked pc light and the container light

on your heat setting you should see less dry, normal dry and more dry. put the setting on more dry and that should take care of the problem. and for the airways. first check your lent trap and if that doesn't do it, check your exhaust hose from dryer to the outside and if that is clear you may have to remove rear cover and clean out. i hope this help.

[email protected]

Remove the exhaust venting tubes and clean thoroughly. When lint builds up the moister sensor prevents the burner to 100 % hot causing thsi

For the F:03 problem on the Bosch Axxis (WTE86300US) do all the things mentioned in Solution #1 above. Sometimes the lint in the condensation filter channels (those that run from front to back)can be quite stuck. Use a pipe cleaner to get in there or a garden hose with a spray nozzle. However there is one more crucial step not mentioned in the manual or in Solution #1. Once you remove the condensation filter you will see a small plastic panel on the lower wall of the condensation filter slot. Slide a flat blade screwdriver and gently pop it open. Under the panel is a small chamber where you will find a slurry of lint/water which is what clogs the condensation outlet. With latex gloves reach in there and clean it out. Blow hard into the dryer through the condensation hose to clear up any last bits. Pop the panel back in place. This should fix your problem.

Remove all 3 filters, half moon filters below door, filter in door and heat exchanger from front of appliance and rinse under warm water dry and refit.

An easy way to check dryer function is to check the airflow on the outside of your home at the exhaust the vent. While the dryer is running, and hot, put your hand near the outlet. The air coming out should be hot and forceful. If not, there is most likely an obstruction, and the whole airway should be cleaned. Keeping the airway clean and clear can dry clothes faster and save you money.

Another possibility is the blower,(fan) which can become encrusted with lint, preventing it from moving air. This is much less likely, but still a possibility.

Add the requested rinse aid.. The light is on telling you it's low/empty.

unplug and wait a few minutes and see if it resets itself,mike