Washer shuts down after running a minute - Dishwashers

Not enough water VOLUME and pressure to supply the pump with a steady flow of water. Water is cavatating (adding air to the water) and the piston is heating up and jambing. Try using a larger size hose diameter and a shorter hose to supply the pump.

Did you turn the choke off after starting unit

not sure if this link will help you out but have a look.
Frigidaire affinity washer shuts down after 5 minutes Google Search

Check the program controller unit, check if there is any loose connection to the wiring to the controller, the relay or the motor and the power plug.
When the machine shuts down then check on the power to the unit , check the door switches, the sensors , in case there is a false alarm..

Could be that the motor is low on oil, if the Honda engine runs low on oil it will shut down after running for a couple minutes. I would check that first. If you still have a problem next time before it shuts down take the gas cap off, it is possible that your gas cap is bad and is causing a vapor lock in the tank. Anything other then these items will indicate that something is wrong with the carb.

Have you checked the oil level? Some engines have a sensor that shuts it down if the oil is too low

Have you checked the oil level?

I had this problem with new duet sport washing machine. Service was out to fix under warranty (4 trips!) replacing water sensor and boards. Finally checked outlet and was told no neutral. ?? Charged us for that visit since not covered. Plugged into another outlet and it worked. Had electrician in, replaced original outlet (although saw no sign of bad connection) and washer worked again! Yippee until today when I had the same issues. Tried in another 2 outlets and still shut down after a few minutes (and in those few minutes it never really ran as it should) Went out to get an outlet sensor ($8 at hardware store). Plugged in and found no errors. Started washer again and it did run and completed cycle. Although estimate 1 minute of final spin cycle took almost 25 minutes (on QUICK wash no less!) Will have to monitor. See if we get lights on outlet sensor next time washer doesn'twork, see what other things in house are running, etc. (although washer on dedicated line). ONLY change since this happenned: We replaced our 30 y.o. electrical box. You'd think this would be better???

you have something gotten into your pump ,,, it trys to drain and spin but overloads the motor and shuts down till the motor switch resets .... remove the pump and take out whatever gotten in it and if that not possable replace the pump.

Hi this could means that you may need to replace the washing machine bearings. Once the bearings are bad, the motor overheats and it will automatically shut down after the first rinse.

Timonty from WashingMachineAdvisor.com