Error code e52 on frigidare dryer what could be wrong?

https://www.google.com/search?q=Magic+Chef+washer+and+dryer+combo.+Error+Code+E52

FIXED - ATF8000FS1 Error E52, intermittent final spin

https://www.applianceblog.com > mainforums > threads
Mar 11, 2019 - Hi, E52=Bad signal from tacho generator. Refer to test (8). TEST 8: 1. Disconnect the plug from the ...

That error code is a motor fault.

Hello friend, thank you for your post!

Based off the information you have provided, I understand that your Frigidaire dryer is displaying an "E52" code and the dryer will not start. Typically an "E52" code stands for motor fault, I would attempt to perform a reset on your appliance by disconnecting power for roughly ten minutes. After the reset if you are still receiving the error code I would recommend having a professional come out to diagnose and repair the appliance. Best of luck. -Matt

E51 - Motor power triac short-circuited.
E52 - Intervention of motor overheating safety cut-out.
E53 - Motor triac "sensing" circuit faulty.
E54 - Motor inoperational.

Dado

Code E52 means the computer memory has been reset, usually because the battery has been disconnected or the computer has lost power.

Hello John Sterns - First, try resetting the unit dryer by unplugging it or flipping the household circuit breaker off. Wait approximately ten minutes. Restart unit and if it proves to be ineffective then typically this is something that a professional would need to diagnose. Since it is such a complex unit, there are multiple possible causes; faulty power cord, house wiring, defective control board, thermal limiter or door switch.

You have a motor error. Remove any load from dryer and check if drum turns freely by hand. Check L1 power supply voltage, motorwindings, and motor thermal protector (if motor thermal protector has tripped,it may take up to 30 minutes to reset). If error persist, replace the motor with this new one.

Hello drew_wedemey -Typically error code E52 indicates that the unit has a faulty motor. If the drum does not turn freely by hand, then I highly suggest contacting a professional to accurately diagnose the following; motor windings, L1 power supply voltage and the motor thermal protector.

Please CALL Frigidare. We have had the same problem with our dryer and now the washer quit! Our set is only 3 years old! With all of the problems reported on the Internet there should be a recall on this set! They need to be informed! I am highly disappointed in the short lifespan of the Affinity Washer and Dryer. Dont know if I would purchase this brand ever again!

that's a lot of kids... according to the Frigidaire wiring diagram and codes list E68 means a key is stuck or bad board. You can enter function test mode and check which button is at fault. Hope this helps Tim

p.s. here is a thread:


http://forum.appliancepartspros.com/dryer-repair/143380-frigidare-affinity-dryer-e68-error-code.html