Algotex plotter the firmware must be configured

Hi Raul, look for tutorials on the Internet, there is a lot of information you can look for
Also try to search Forums, where you can register and Ask questions
Ask at the house where you bought it
I hope you can solve the problem
Regards Franco Dosil


Hola Raul, busca tutoriales en Internet, hay mucha informacion que puedes buscar
Tambi?n intenta buscar Foros, donde puedes inscribirte y Hacer consultas
Pregunta en la casa donde la adquiriste
Espero puedas resolver el problema
Saludos Franco Dosil


http://www.mucad.com/cmsmultilanguage/uploads/data/plotter/stream180.pdf

What kind of plotter. Reading the error it appears that some process is freezing up. This can be caused by a corrupt print job, bad driver. First step you want to take is to update the firmware on the plotter.

Follow instructions from the link. DesignJet 500 firmware upgrade

Press F5+Settings button in Algotex Server Software.
Then Defload password in Software.

there is a common fault on this particular printer which also affects the t770/t1200
when trying to feed a new roll of paper the plotter is asking to remove the paper from manual feed even though there is none.

the fault lies with the way the plotter is using the manual feed sensor,
there has been a technical release from HP regarding this same issue.
what to do -
1) firstly you need to find out whether the sensor really is at fault or if there is another fault which is confusing the manual sensor output.
a:- upgrade the firmware on the plotter ( always make sure your plotters firmware is upto date), cycle the power of the plotter and retry.
b:-use your user operating guide to take you through 'calibrating manual feed sensor' and retry.this is a quick process which sets the values for paper present/not present on the formatter.
c:- if the above two have failed then order a new PCA and calibrate the sensor immediately after first initialize of new Main PCA.

if the sensor fails to calibrate then I would first order a new sensor ( cheapest option first) if that fails then replace the main PCA. but always first check for any new firmwares.

dear sir/madam,

in this hp designjet 4520, this error comes up :error code 24:10. when i enter it, in the service manual it shows: Broken bag detected in Ink Cartridge. but it doesn

check and replaced the i/o card or install to other slot

This data is printed out on the Service Configuration Print

1. Load the plotter with media.
2. When the device is 'Ready' scroll the menu to the Printer setup options and press Enter.
3. Once in the 'Printer Setup options' menu, use the arrow keys to scroll to 'Utilities', and press Enter.
4. In the Utilities menu, use the Arrow key to scroll to 'Test Prints' and press Enter.
5. Use the arrow key to scroll to 'Service Config' and press Enter to print the Service Configuration Print.
   

You should find the data you are after under the heading of Maintenance on the printout

Good Luck!

Manuals for the driver and plotter setup can be found here:
http://h20000.www2.hp.com/bizsupport/TechSupport/Home.jsp?lang=en&cc=us&prodTypeId=18972&prodSeriesId=24023&lang=en&cc=us

hp will never tell you but this error is a kind of a catch all error basically the service manual says to reload the firmware. check the file you are sending. i have seen a bad file cause this error. hope this helps.