Reset fuser counter
These are all wrong suggested answers below... seriously dont tell people to touch wiring harness and internal parts if you dont know what you are talking about.. to reset the fuser you need to enter the maintenance mode, which is described here: https://www.manualslib.com/manual/1060356/Konica-Minolta-Bizhub-20.html?page=384 and then you can reset all maintenance parts.. I hate when people give answers that are completely unnecessary.
Why do you want to reset
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f
SOURCE: bizhub C250, Total Counter Working but not B&W or Colour Counter
Unfortunately you cannot reset those electronic counters.
I'd suggest reloading the firmware to try and solve the issue going forward.
SOURCE: need to reset the fuser counter
Hi there.
Download Service Manual here: http://nodevice.com/manual/Konica_Minolta_QMS_magicolor_7300_Service_Manualpdf/get690.html
and follow the instructions.
Regards.
SOURCE: Need to reset the fuser and transfer belt alarm in
can not be reset .it has to be reset manualy by a technician or replacing the units...
SOURCE: can you reset fuser counter without replacing the
You can. You have to remove the fuser, and replace the counter reset fuse that is soldered into the wiring harness, then re-install the fuser. 10 minute job but not a one I would recommend unless you know the machine pretty well. Depending on your location and service options I would try to find a local independant repair person who can do this for you. I reset 20 to 30 of these fusers per year. Note you can also reset your transfer belt unit as well as your Imaging Units as well.
Good Luck and Thank You for using Fixya.
WheatlandServices
Testimonial: "thank you very much. I can tell, you're really an expert. your response was very helpful, i will contact a good technician right away to change fuse."
1,316 views
Usually answered in minutes!
×