How to ajust bulbs

Hi,just inline the crankshaft to the top dead centre marks,then check that the camshaft marks line up,if they dont line up then turn the crankshaft pully again untill the camshaft marks line up,slacken the timeing belt pully adjuster take belt off and replace with new one,tighten the pully adjuster back up,now put a spanner on the crakshaft pully and turn clockwise untill the top dead centre marks and the camshaft marks inline if they dont then slacken the ajusting pully inline marks again and try again,if marks do inline ok then you are ready to start the car.
hope this helps good luck.

TRY GOING IN MENU AND AJUSTING PIC QUALITY
INCREASE THE BRIGHTNESS , IF YOU CAN

Hello,

does the TV bring out sound even as the screen display is dark?

Problem should be from the TV lamp/bulb. When a TV bulb/lamp is dying, it makes the pictire on the screen become dark and very hard to see.

Have the lamp replaced and hopefully, your screen should be perfect as before.

Let me know if you need directions in replacing the lamp, even though it is very simple replace.

Yours sincerely.

Elect_Comp.

you must ajust side tracks on either side.they have ajustable both.loose and tighting to right ajustment to you get it right.

open the back of your tv and there will be a small box hanging from the crt cage those little knobs control focus and brightness you can set your set in front on 50 percent or "default" and then ajust the brightness of each crt bulb behind the tv.

try this restore to defualt values monitor and cpu

Does the primer bulb pop back out or does it come out slowly? Is the inline hose in good shape or has a crack where it can **** air in? Did you check to see if the diaphgram in the carb is pliable or is it paper-like and needs replaced. Or your carb could be stopped up.
Only one problem..I can't think of any weedtrimmer that has an inline fuel filter. They are usually located in the gas tank.

Pull the knob off of the oven control and see if their is an ajustment. If the ajustment doesn't work then change the thermostat bulb. It goes for the oven to the back of the oven control know

if you didnt play with the ajustment it should be the same if not the light is not install the right way move the bulb it should work thanks pierre

go to menu- go to setting -go to colour move slider to right hand direction befor you change the lamp -take care that some vga cabel(((cabel between pc and projector make this fault).then you have to change this cabel and try.