My camera fell... Everything it's working, unless the power button and the shutter. What can I do?

maybe button inside already defect...go to a camera repair shop to change the shutter button

Sounds like a loose screw inside shorting out one of the curciut boards! tccamerarepair.com

Well yes.. Personally I would make a little Button from something and seat it in there, and use it like that?

I bought a "for parts" dscw50 off ebay & unscrewed the side panels; this allowed me to remove the whole top panel (entire silver piece) & exhange it with the one on my own camera which I had broken the shutter button off of. Works fine now.

Hold the power button in the ON position for 10 seconds, then release (obviously making sure the batteries are in first). This forces the camera to do a full reset - you will have to set the time etc when it restarts.

Hope this helps, it worked for me...

unless you can get them free , don't waste you time on them
they were a cheap camera to start with

My camera fell out of my pocket book and busted the door. I glued it. that worked for about 6 months. I need the door for it and it will be as good as new.

If you cannot find a solution to your problem you may want to email [email protected]. He has good advice and good used parts at a fair price.

Whilst there may be another fault, replacing the battery cover is a good start and you need to eliminate all possible causes.

These cameras also only reliably run on Lithium batteries.

I've seen many sets of fresh alkaline batts not work, even though they show full power.

Lithiums are more expensive, but they last much longer than several sets of alkalines, which ends up being far greater $ value and you are not constantly changing batts.

Worth a try.

hi it depends on where it broke and if...(the button) if it just fell then u can just take the new button a shove it in untill theres a CLICK if its broke then u will need to pull out the rest and then shove it in DO NOT TRY TO OPEN THE CAMREA IF U DONT KNOW HOW!! you will brake the pins inside when u will and then it will cost u as a new cam good luck windman