My Maytag Atlantis has a strange problem I can’t figure out. When I start the washer it runs fine until it gets to the rinse cycle. Once in the rinse cycle is just fills and drains the water at the same time. It will continue to do this until I stop it. It does the every time. I have replaced the timer and water level selector and hose. Sometimes it also does this when I first start the washer. I will start the washer, the tub will fill with water and then drain it. Sometimes it won’t even fill because it drains the water as it enters the tub. Any ideas?? Thanks.
I HAVE AN ATLANTIS MAYTAG WASHER . I HAD THE SAME PROBLEM AND I SOLVED AS FOLOLWS. REMOVED THE MOTOR, I APPLIED GENERAL PURPOSE GREASE ON BOTH SIDES OF THE SLIDING MOTOR SURFACE PLATE (MOTOR BASE) . THE GRASE HELPS THE MOTOR TO SLIDE BECAUSE AS YOU KNOW THE MOTOR DOES NOT HAVE ANY ADJUSTMENT. TRY IT PLEASE . GOOD LUCK
Is your drain hose at the top of the washer .is the water just runing out is it being pump out
1,379 views
Usually answered in minutes!
Yes it is near the top. I believe the water is being pumped out because the water is draining the same speed it fills.
×