20 Most Recent Onkyo TX-SR606 Receiver - Page 2 Questions & Answers

Please be sure that you have turned on RIHD in the setup menu under Hardware and HDMI as that will set ARC to AUTO. Please also note that you will want to make sure that the HDMI cable going from the output of the receiver is connected to the HDMI input on the TV that shows ARC. If you require further assistance please feel free to call us at 800-229-1687, Thanks, JT

Perhaps you just use a cable like this: use the tulip plugs and plug them into the AUX of the amplifier. Then at least you can play the music via the receiver.

We no longer provide service manuals to customers to prevent unathorized and accidental internal damages to the unit and previous history of fraudulent claims of manufacturial defects. We apologize that we can't provide a solution for this request.

i hate to say it i got the same problem and the only way i sorted was a master reset which means u have to do all the set up again and asign all the hdmi again but since i done that no problems to do this un plug the lot for an hour reconnect everything then push and hold the vcr button and push stand by a message will say clear on the receiver then it is back to when u frist got it out th box hope this helps

hi

Have you tried powering it off fully (holding on/off button until it switches off) then leave it for 30 seconds, and switch it on again. hope this help.

David is wrong. My Onkyo is the same way. The receiver will only provide a signal to zone 2 speaker outputs from analog sources. I assume this was because of concerns with digital rights management, which caused some odd decisions for a while by hardware manufacturers. Newer receivers should not have this problem.

Make sure Speakers A + B buttons are both pressed in. Run the test tones. If you can hear Test Tones then it's just a configuration issue.

Make sure Speakers A + B buttons are both pressed in. Run the test tones. If you can hear Test Tones then it's just a configuration issue.

Check the RCA cables. They might have been interchanged somewhere when you were plugging them in. If you have plugged them right, but still no video, try another cable. The first cable could be defective already.

Sorry but it needs to go to the shop.

I have similar problem with my Onkyo Tx-SR600. It only happens when it's in surround mode. When switch to Stereo or Direct, the scratchiness go away. Still trying to find a solution to this problem.

Yes you can run optical lead from sky box to receiver in the sky box setting you need to tell it that you are using optical and on the receiver u need to bind 1 optical with hdmi input this is done though input settings hops this help

Not sure if this is your fix, but I had what I thought was the same problem. I played with my Onkyo quite a bit ensuring the correct assignments for HDMI, audio and all that stuff. Turns out I neglected to make sure the output devices were properly assigned. Many devices aren't default to output sound over HDMI. I changed the audio out settings on the cable box to HDMI and suddenly the Onkyo worked great. I know, I'm an idiot for not checking that in the first place, but maybe someone out there is having the same trouble as well.

Just telling because it happened to me... Is your optical cable connector well inserted? you have to appy a little pressure until you feel a snaping sound. Also, in case you wouldn't have the manual, here it is: http://www.intl.onkyo.com/downloads/manuals/pdf/tx-sr606_manual_e.pdf page 57 and over good luck,