Blodgett DFG-100 Gas Single Oven - Page 2 - Answered Questions & Fixed issues

1st stept check the ignitor if what happen...
2nd check the connection of wiring sometimes the wiring is loss

chek the pipe line and the small part the pin gas realeas >>use by the small niddle to clean

Your pilot light is probably blowing out. If you follow the pilot light gas line from the pilot flame back to the main valve, you will see a screw about the size of a pencil in diameter. If you take that screw out, there is another screw down in the hole you just uncovered. You have to have a very small screwdriver to reach that screw. If you turn the little screw counterclockwise, the pilot light flame will get bigger. A lot of times this will help. If you have a drafty location, the pilot will get blown out and that shuts the main gas valve off.

Hi i was reading your problem go to the appliances parts store tell them you need a gas valve Regulator that will change it from lpg to natural gas its natural gas it needs on the the 10 psi i think it should go back on the 25 psi thats only Regulates the flow of gas to high an to low dats all..i can be reach [email protected]

dirty pilot?

I have seen this happen when a hole develops near where the ignitor is mounted. The excess gass overheats the ignitor and burns it up. What I do in a case like that is slide a c clamp over the burner and cover the hole. If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Call scott at ICS 1800 243 1290

Be sure that the igniter has a good ground. I mean make sure you clean it well. Be sure its fastened well. And of course that it is close enough to burner. Air flow in building can also hinder lighting.

This is caused by a faulty pilot safty valve. it will be the tee looking valve with the red dime sized button in the middle.

Hope this helps You
please rate me

I know what you mean. I was cooking with this appliance tonight and suddenly it displayed an f-3 code. My advantium oven is less than 8 months old. Not sure how this happened or how to fix the problem. In order to sleep tonight (the constant beeping) I had to shut power off at the breaker pannel. Is this representative of the the type of quality that GE stands for???? I am sooo frustrated. I cook with my advantium oven all the time and love the dual abilities of this appliance. Like I said this is brand new and to have the f-3 code which apparently (from what I read) is a failed key pad. I am very dissapointed and am begining to think about pulling my stock from this company!

A good pre-heated pizza stone will help cook the crust better when the pizza is placed right on the stone. As for the cheese burning, check the actual temp. of the oven with a good thermometer.

Do you need sumthing?Driver software help????

yes it is, advise the salesman that you will stack the new oven with your existing one.

Please go to google search engine.definitely you will get the qnswer.

Door switch, gas valve, temperature control, selector switch?

You can you have a lot of money.

Dirty burner nozzles is the likely cause.

Model and serial numbers will help

it has been some time since I have done this but if I remember correctly, the replacement glass comes with a special tool for the trim around the glass and instructions. I suggest calling a supplier, such as Restaurant Parts and More, Heritage Parts, or PartsTown and ask if this is still the case that the tool and instructions are included with the glass.

Sorry but question appears incomplete ??