Top 20 Kenwood KDC-MP205 CD Player Questions & Answers

Try Kenwood's website to see if at installation manual is available.

Hi there,Sometimes, car owners inadvertently clean the displays with harsh chemicals, which can react with the facia plastic.The only method I can think of in this case, would be to try a light abrasive plastic polish such as Meguiar's Plastix or similar. These creams are designed to remove light scratches on plastics (such as headlight lenses etc), but in your case, we are trying to polish the display back to a satisfactory optical finish.Good luck.

Kenwood has the manuals for most of their products here: http://www.kenwoodusa.com/Support/Car_Entertainment_Owners_Manuals/. The direct link to the manual for the KDC-MP205 is http://www.kenwoodusa.com/UserFiles/File/Global/Consumer/Manuals/KDC-MP2035.pdf .

I hope this helps.

Cindy Wells

Unless you turned it off, Kenwood radios automatically have the loud turned on when the radio is first powered up.

Hi, Thank you for posting your question on fixya. I will be happy to help you with this problem. Can you please give us some more information so I can better answer your questions.

What are you trying to use the CD , turner for...?is it for aux purpose or,just to play CD...?


Thanks.

The blinking red light is to let thieves know the face is not on the radio and is not worth stealing. the blinking red light doesn't draw enough power to drain your battery.

You can get a new face at pacparts.com.

There should be a wiring diagram that came with the head unit. Check that and match up the colors to the on in the car. Assuming that you have the right wire harness that matches your car. There is normally a pattern that you'll catch on to when your wiring it. you should have 4 pairs of wire for the speakers, 1 ground, 1 hot, 1 for power ant., and an aux, also a clock, and maybe an ignition.

Try pacparts.com.

if you no longer have any warranty consider buying a new unit as repair would be uneconomical.

please reply in english

You can get the wiring diagram on the link below page 26

http://www.masterspas.com/manuals_av/Kenwood_KDC-MP2035.pdf

Good Luck

Unless there is something wrong with the head unit, there must be a shorted connection. Try doing the same with no speakers plugged in and see if the protection breaker trips.

If it does not, then one of your speaker cables is shorted. Try installing the cables one by one, and test it, to see which one is at fault. Other remote possibility, is that one of the speakers is blown.

Hope this helps (remember to rate and comment this answer).

yes

black is ground and yellow is constant power.

you will need to purchase this wire, Click Here one end goes in the headphone jack on your ipod and the other will plug into the stereo

press and hold the menu button for a few seconds. use the am/fm buttons to scroll through the menu. when you get to clock mode, press and hold either the seek up or seed down buttons for a few seconds. when it starts flashing, use the am/fm buttons to adjust the hour and the seek up or down to adjust the minutes. press the menu button again to exit. to exit the menu, press the menu button once again.

press the menu button for a few seconds. this should get you into the menu. use the am/fm buttons to scroll through the menu.

Press the SRC button to turn unit on. The SRC button allows you to navigate between input sources,i.e. tuner, cd, aux, etc. Press and hold SRC button for second to turn unit off ( it will display standby).

check to make sure that none of your speakers are blown. if your handy pull the deck out and double check all power connections and make sure that every
thing is connected well.