Top 20
Audiovox Jensen In-Dash DVD/CD Receiver w/ 7 LCD Screen" Car Video Player Questions & Answers
How to bypass e brake
The remote has nothing to do with bypassing the e-brake. Not to mention the fact that it is illegal anyway.
WHERE IS THE RESET BUTTON
isn't there a way to bypass the parking brake so my video plays anytime i want
can only see my video when i park and i bought for long trips so my girlfriend wont get bored VM9311TS
The Jensen dvd player won't play all dvds. It says
New player? Under warranty? Take it to whoever installed it. Sounds like a weak laser, or a laser alignment problem. Could also simply be a dirty laser lens, but proper cleaning requires disassembly (those laser cleaning discs are hit-n-miss, and I've seen them actually damage the laser pickup, so I do not recommend them).
I have 7inch touchscreeni can
it is muted. try to look for the speaker icon with an "X" that indicates muted speakers. If no such icon, your volume is ZERO. Now press the + key with the speaker icon which indicates the volume control.
PARKING BRAKE DISABLE
yes its saying in toorder to play dvd's u must engage parking brake which means the wire is suppose to be hooked up to the parking brake....BUT i know the trick to make it work where u can play dvd's and drive
How do i hook up my parking brake
in the directions it should either tell you to attach a wire from the radio to the ebrake so you can get video. i dont like that idea . first try and ground and ground the wire to the back of the unit. some manufactures incorparate a sequense ex- pull e brake three times then the video will work . what i have done with these is put a small button in the center console or somewhere out of the way . if you want to hook it up the way they want it i need to know what kind of car you have ...
I have a Jensen flip
sounds like a bad spot in your ribbon cable. it runs form the laser assembly to the circuit brd. you could have some dirt on the sled rails..either way the radio will have to be taken apart..if you can do this yourself the ribbon cable is not too expensive...labor is what gets you..
PARKING BRAKE DISABLE
Welllll just connect it to GROUND! which is anywhere on the frame.
its a negative flow.
JENSON vm9312 Video Bypass
check this out man, go to fm/am mode. with the remote hit the setup botton. then enter 543210 and be sure it beeps on every diget. then hit the hammer/screwdriver icon and turn the parking brake "on"
What are the input wires on a audiovox amp777
The Audiovox AMP777 is a 4-channel power amplifier, and the input wires will depend on the audio source you are using. Typically, the amplifier will have RCA input jacks for left and right channels, and you would use RCA cables to connect the audio source to the amplifier. Some amplifiers also have a high-level input option, which would allow you to connect speaker wires directly to the amplifier's input terminals. However, it's always best to consult the user manual or contact Audiovox support for specific wiring instructions for your amplifier model.
Not finding what you are looking for?