Lexmark Prevail Pro705 Wireless All-In-One InkJet Printer - Answered Questions & Fixed issues

Enter the Service mode following the procedure below. (1) Turn off the printer. (2) Turn on the printer while holding down the [Paper Source]key and [Informarion]key. *Keep pressing the above buttons until "Initializing"appears on the display.

you need to download the drivers so it will be recognized by the computer. go to lexmark support.go to downloads section,find model number and look for win8 driver..

install lexmark printer no disc in Xp

Please visit the Lexmark website to download and install the Lexmark Prevail Pro705 Printer Driver on your computer. Select your operating system > click on "FILTER" > click on the driver under Recommended Downloads > download and execute the file. Simply follow the instructions on your computer screen to complete the installation.

If you lost the original disk you will need to contact Lexmark. Keep in mind that most of the OCR software they license from other vendors so they may charge you for it.

http://www.lexmark.com/publications/pdfs/2007/2009-fall/v9842009_en.pdf

Try this if all else fails.

Sounds like you need new printhead. Take a look on amazon here: Genuine Lexmark 100xl 100 Print Head 14N0700 14N1339 Printhead for Lexmark... I hope this was helpful. cheers

Sounds like you need new printhead. Take a look on amazon here Genuine Lexmark 100xl 100 Print Head 14N0700 14N1339 Printhead for Lexmark I hope this was helpful. cheers

Sounds like you need new printhead. Take a look on amazon here Genuine Lexmark 100xl 100 Print Head 14N0700 14N1339 Printhead for Lexmark... I hope this was helpful. cheers

The hinge is probably broke. Watch this video on how to get around the problem Lexmark Printer Pinnicle Pro 901 ADF Hinge quick fix Revised

If your adf is jamming while it is feeding it might be due to a broken hinge. Check out this video.https://www.youtube.com/watch?v=GaS0oKcreBo

Try to do a printhead cleaning operation. Possible that there is not enough black ink in the printhead.

On my 901, I can reduce the size of the PDF file by changing the "quality" setting in the scan mode. More specifically, reducing the DPI that it scans at. I also noticed that scanning a document to a wireless network computer, and then scanning the same thing again directly to a flash drive plugged into the printer, results in significant variations of the file size. Perhaps trying different combinations of these things will help you with your problem. Good Luck.

could be the document size or not enough memory or if you are printing from a network could be network traffic... try deleating the current driver software and reinstall the new software using the disc that came with the printer I’m happy to help further over the phone at https://www.6ya.com/expert/ron_9356d26241d4cbf7

Finding a hinge is almost impossible, but you can do a fix on your broken one that will get your adf working properly again. Watch the video. Michael

In the driver choose Print Black and White

They have to both be set on the same wireless address

Do a Clean Printhead operation. This will usually correct the problem.

Try turning your printer off and unplugging it from the electric outlet. Wait about 5 minutes and then plug it back it. This should reset your printer.****If you need any technical help on printer then you can reach at here