20 Most Recent GE Profile Performance WPSF4170WAA - Page 9 Questions & Answers

Drain pump may be clogged or screens in hoses and water valve may be stopped up

Unplug it for 15 min.. Cheers

Assuming water is cut on at faucet, be sure hot and cold lines aren’t reversed. Also check screens in hoses and valve for debris.

It's going to cost you if your not handy as the problem is more than likely a small board which sends a message to a relay, but not the relays of the good old days.

check the breaker. is it a gfci?

https://products.geappliances.com/appliance/gea-support-search-content?contentId=19152

Likely pump failure.

If the FILTER is not cleaned after each load was completed this will happen.

Seized tub bearing

Replace the seal or rubber of tub

Stability arms are the problem if it leaks during the Spin cycle. If it leaks on Wash or Rinse, the pump is bad.

Is hot hose connected to hot faucet and cold to cold? When you had hoses off did you make sure water was coming out when cut on at faucet? If all is well with hoses and water supply, then your water valve may be bad. It also could be a control board issue

Faulty water level sensor.

Check suspension rod bushings at top.

The belt could possibly be to tight

Check drain pump for obstructions

Lid switch may be bad

Lid lock is most likely bad

If nothing is wrong with switch or latch, it’s a control board or wiring issue.