20 Most Recent
Yamaha 2011 WaveRunner FX Cruiser SHO - Page 6 Questions & Answers
Wiring Yamaha outboard tach
Yellow wire is batt+ after ignition switch
Black wire is the ground
Yellow wire is the rev-pulse
Blue wire is the light.
How do I repair the loose steering on my Yamaha 8 hp outboard?
Hello,
There is a 'brake' screw (with a spring around it) on the vertical tube under the engine.
Screw in the have a stiffer steering.
If it still don't stiff the steering, the system inside is worn out or bent.
You'll have to remove the 4 bolts holding both halves together and remove the complete engine from the steering bracket to get access for repairs.
Adjusting idle on 115 4 stroke Yamaha
There is NO idle speed control...
The idle speeds is automatically regulated by a valve system piloted by the ECU.
You have an eventually 'trolling speed setting' with electronic rev-counter.
Outboard yamaha 350hp 4strokes 2000 how much timing where is the timing point
There is no setting possible.
The ecm monitors the combustion quality and adjusts the timing following the results.
It works with "ionic combustion sensors" - adapted for the first time on an outboard. They monitor combustion conditions by detecting the production of ions in the flame. The ECM adjusts the ignition timing based on the ion density to improve combustion.
I have a problem with my 2003 yamaha waverunner
It's not possible to be 100% certain with your information but I will follow the following sequence; first take out all the spark plugs and inspect if they are too dry or with metallic residues (this could tell you about a big failure in the cooling system or lubrication and a possible mayor engine failure) , second try to run the engine with the starter, it has to run very easy without any strange metallic noise. apparently you run your waverunner without correct lubrication or water cooling circulation and the engine was over heated.
How to test powerpack Yamaha 150 trx carbed outboard
You can not test any power pack. You have to test all other ignition components first. If all components test good it could be a bad powepack. First thing first, check ground wire, check all grounds. Make sure no carosen, or loose bolts. Your also want to ensure wire to terminal has a good connection.
Not finding what you are looking for?