Top 20 GE Spectra JBP78 Electric Kitchen Range Questions & Answers

Try setting the oven to [CLEAN] Then after 2 Minutes check to see that the door has locked. After a total of 4 minutes Clear/Stop. WAIT at least 10 minutes the see if the door then unlocks and the icon clears. If not, then the door switch, or control board are bad.

You suppose to change filter every 6 months

Control board is bad.

May not have been pushed or plugged in all the way-or had some grease or misc particles inside plug in on female side

Could also be the clock / control. You can ohm out the element with a meter to determine if element is bad.

believe it is 2008 prod. I’m happy to assist further over the phone at https://www.6ya.com/expert/howard_977676954994c5b2

It could be a bad temperature probe

there is a serious problem with the electric connections the click is probably a thermal circuit breaker switching off call an accredited electrician to check it out

Any small bit of metal getting on the element can cause it to spark. Make sure its clean and any metal pot bottoms have no sharp edges etc.

You have something that is a BAD connection. It could be dangerous. Time to call appliance service, but ask for an estimate first.

• TO TALK TO GE DIRECTLY CALL THE NUMBER BELOW:
• Phone Number

  800-626-2005

  Call Time Average Wait: 5 mins - Monday-Friday: 8 a.m.-10 p.m. ET Saturday: 8 a.m.-7 p.m. ET

clean the contacts in the control panel 0000

I know this is an old post, but, I took Oven Troubles advice and pulled the circuit panel and found two of the posts on the board under the plug to be cracked. I soldered all the posts and have NO F3 / F2 flashes ! Thanks and Happy Thanksgiving!

Unplug the unit and remove the back access panel for the control board. Check for any loose or burnt wires. If none are found, replace the control board. Here is a link to that part. Electronic Control Board Be sure to take note as to where the wires go!

Probably need to check the voltage at the range block itself (where the cord is hooked to). Could be a voltage problem (bad at receptacle) or the wires on the terminal block have gotten loose, broken off.

Remove the lens covering it (screws or clip) from inside the oven. You can buy 40 watt oven lamps.

If it's unplugged, and something is lit, it must be on a battery, like memory for the clock or something.

Which element is it? Try to switch the infinite switch from another element. This will tell you if it is the element or the switch problem.

You will need to replace the surface element switch. Here is the part to order. Below is a video to show you how to replace the switch.