20 Most Recent
One For All URC-4021 Remote Control - Page 8 Questions & Answers
Tv code
The codes are: 0156, 0748, 0765, 0767, 0879.
I have a u r c 4021 i need to program for a phillips tv
Philips TV code might be one of:
002 009 020 109 122 202 209 210 222 310 322 402 408 422 508
510 807 822 901 914 917 919 922
Test to find out which works best for your TV. Look in your TV manual for information about remote control codes, it may tell you exactly which is the right code. If you want more help, post another request on FixYa with the exact model of the TV.
All the best.
EchoStar 5.3IR from Dish Network not responding to Samsung tv
It seems the new, larger tvs these days put out too much light and it interferres with the remote signal. Simply put a post-it note or tape a piece of paper over the lights on the receiver and you have an affordable and instant fix. This isn't a good looking fix and I would be upset if the set were in a living room. Luckily ours is in the family room downstairs.
Cant find the code for my zenith tv
On most universal remote control, you will find the procedure to enter
the builder code OR a procedure to pass through all the code of the
remote, one by one and pass to the other TILL you find the right one.
It happen to me numbers, a bit upsetting procedures, but you'll find out!
I NEED THE CODE FO JVC
1. press and hold setup button until the red light stays on.
2. press and release the desired mode button (example t. v.) the light will blink and then stay on.
3. enter one of the 4digit codes.
note: if the code is valid the light will turn off if it flashes it is an invalid code.
4. with the device on press the channel up and down. if the remote only controls some of the functions try another code.
CODES: 0060,0026,0197,0069,0160,0247,0923,0012,0065,0067,0141
If none of the the codes work try following these steps:
1.manually turn on the t.v.
2.press and hold the setup button.
3. press and release the tv button the light will blink once and then stay on.
4.press the channel button repeatedly up to 300 times until the device changes channels. the light will blink and then stay lit.
5. press and release the mute button to store the code the light will go off.
How to program
what buttons do u push to program say if its my tv what would i push my tv **** and what else
Not finding what you are looking for?